2.17 3G(BTO) Troubleshooting
This section describes how to determine if the computer's 3G is functioning properly.
Perform the steps below starting with Procedure 1 and continuing with the other procedures
as required.
Procedure 1: Diagnostic Test Program Execution Check
Procedure 2: Connector Check and Replacement Check
Procedure 1
Insert the 3G test program in the USB key, turn on the computer and run the test. Refer to
Chapter 3, Tests and Diagnostics, for more information about the diagnostics test procedures.
If any errors occur while executing the 3G test, go to Procedure 2.
Satellite M500/M505/M507 Maintenance Manual [CONFIDENTIAL]
Downloaded from LpManual.com Manuals
Diagnostic Test Program Execution Check
2 Troubleshooting Procedures
2-51