Procedure 7.23 - Replacing A Stairarm Connector (Serial Codes Cr And St, Only) - Precor EFX 5.33 Service Manual

Procedure 7.23 - Replacing a Stairarm Connector (serial
Warning: Care must be taken when work is being performed in the area of the stairarms. Pinch
points exist between the stairarm and ramp and between the stairarm and crankarm,
when the rear covers are removed.
1. Procedure
1. Set the on/off switch in the off position.
2. Remove the retaining clip that fastens the secondary link to the stairarm connector.
3. Remove three bolts, washers and single nut that fasten the stairarm connector to the
stairarm.
Diagram 7.25 - Stairarm Connector Mounting
4. Set the replacement stairarm connector at its mounting position and slide the secondary link
onto the stairarm connector. Replace, but do not tighten the hardware removed in step 3.
codes CR and ST, only)
Secondary Link
5.33 Elliptical Fitness Crosstrainer
Stairarm Connector
Page 75