Onkyo HT-R990 Instruction Manual page 31

4
When you've finished making the settings, press
ENTER.
Perform the "Speaker Setup" according to your
speaker configuration:
– Powered Zone 2
– Surround Back/Front High
When an optional unit is connected to the
UNIVERSAL PORT jack on the AV receiver, the
optional unit setting may appear on the speaker
setting menu.
5
Use q/w to select "Audyssey Quick Start" or
"Audyssey 2EQ Full Calibration".
6
Press ENTER.
Audyssey 2EQ
starts.
Test tones are played through each speaker as
Audyssey 2EQ Room Correction and Speaker Setup
runs. This process takes a few minutes. Please
refrain from talking during measurements and do
not stand between speakers and the microphone.
Do not disconnect the speaker setup microphone
during Audyssey 2EQ Room Correction and Speaker
Setup, unless you want to cancel the setup.
If you select "Audyssey Quick Start", you will go to
step 9.
7
Place the setup microphone at the next position,
and then press ENTER.
Audyssey 2EQ performs more measurements. This
takes a few minutes.
8
When prompted, repeat step 7.
9
Use q/w to select an option, and then press
ENTER.
The options are:
Save:
Save the calculated settings and exit
Audyssey 2EQ
Setup
Cancel:
Cancel Audyssey 2EQ
Speaker Setup
Note
• You can view the calculated settings for the speaker
configuration, speaker distances, and speaker levels by
using e/r.
Downloaded from www.Manualslib.com
2EQ: Auto Setup
AUDYSSEY
Powered Zone 2 No
Surround Back/Front High Surround Back
(➔ page 43)
(➔ page 44)
®
Room Correction and Speaker Setup
2EQ: Auto Setup
AUDYSSEY
-- Review Speaker Configuration --
Subwoofer : Yes
Front : Yes
Center : Yes
Surround : Yes
Front High : No
Surround Back : Yes
Surround Back Ch : 2ch
Save
Cancel
Room Correction and Speaker
.
Room Correction and
.
manuals search engine
10
Use q/w to select a target, and use e/r to change
the setting.
After the results of Audyssey 2EQ have been saved,
the menu will display the "Audyssey"
"Dynamic EQ" (➔ page 48), "Dynamic Volume"
page 49) settings.
(➔
Note
• When "Audyssey Quick Start" has been used for
measurement, "Audyssey" cannot be selected.
• These settings are applied to all input selectors.
11 Press ENTER.
12
Disconnect the speaker setup microphone.
Note
• You can cancel Audyssey 2EQ Room Correction and Speaker
Setup at any point in this procedure simply by disconnecting the
setup microphone.
• Do not connect or disconnect any speakers during
Audyssey 2EQ Room Correction and Speaker Setup.
• If the AV receiver is muted, it will be unmuted automatically
when Audyssey 2EQ Room Correction and Speaker Setup
starts.
• Changes to the room after Audyssey 2EQ Room Correction and
Speaker Setup requires you run Audyssey 2EQ Room
Correction and Speaker Setup again, as room EQ characteristics
may have changed.
(➔ page 48),
En
31