Remote Controller Setup; Lock Setup - Onkyo TX-NR828 Owner's Manual

■
Bluetooth
This setting enables the AV receiver to pair with
Bluetooth-enabled device.
Status
Press ENTER button to display "Now Pairing" and
start pairing.
Tip
• If pairing setting is not set, "Ready" appears on-screen
display. The name of the device paired with the AV receiver
is displayed if pairing setting is set.
• For details on the Bluetooth connection, refer to the
instruction manual of the Bluetooth-enabled device.
• The pairing can be done by holding down BLUETOOTH
button on the AV receiver until BLUETOOTH indicator
flashes.
Note
• This setting cannot be selected if you've selected NET or
USB as input selector in Multi Zone.
Initial Setup
If you skipped the initial setup wizard, for example on
first-time use, you can reaccess it from here.
See "Initial Setup" (➔ page 25).
Note
• This setting cannot be selected if the "Monitor Out" setting
is set to "Sub".

8. Remote Controller Setup

Remote ID
■
Remote ID
1, 2, or 3
When several Onkyo components are used in the
same room, their remote ID codes may overlap. To
differentiate the AV receiver from other components,
you can change its remote ID from "1", to "2" or "3".
Note
• If you do change the AV receiver's remote ID, be sure to
change the remote controller to the same ID (see below),
otherwise, you won't be able to control it with the remote
controller.
Changing the remote controller's ID
1
While holding down RECEIVER, press and
hold down Q SETUP until the RECEIVER lights
(about 3 seconds).
2
Use the number buttons to enter ID 1, 2, or 3.
RECEIVER flashes twice.
Remote Mode Setup
See "Looking up for Remote Control Codes"
(➔ page 82).
En-78
Advanced Operations

9. Lock Setup

With this preference, you can protect your settings by
locking the setup menus.
■
Setup
Locked
Unlocked
When "Locked" is selected, the setup menus will be
locked and you cannot change any setting.
Operating
procedure
(➔ page 60)