Remote Controller Setup; Lock Setup - Onkyo TX-NR727 Owner's Manual

■
Proxy Port
If you're using a Web proxy, enter a proxy port
number here.
■
Network Standby
On
Off
This setting enables or disables control over the
network.
When enabled, the NET indicator will be dimly-lit
while the AV receiver is in standby mode. Note that
the indicator may not light under certain conditions
(➔ page 22).
Note
• When set to "On", the power consumption slightly
increases in standby mode.
■
Update Notice
Enable
Disable
When this setting is enabled, you will be notified if a
firmware update via network of high importance is
available.
Note
• Selecting "Never Remind me" on the notification window
will switch this setting to "Disable" (➔ page
• For details on the update notification, see "Firmware
Update Notification" (➔ page 22).
■
Bluetooth
This setting enables the AV receiver to pair with
Bluetooth-enabled device.
Status
Press ENTER button to display "Now Pairing" and
start pairing.
Tip
• If pairing setting is not set, "Ready" appears on-screen
display. The name of the device paired with the AV receiver
is displayed if pairing setting is set.
• For details on the Bluetooth connection, refer to the
instruction manual of the Bluetooth-enabled device.
• The pairing can be done by holding down BLUETOOTH
button on the AV receiver until BLUETOOTH indicator
flashes.
Note
• This setting cannot be selected if you've selected NET or
USB as input selector in Multi Zone.
Initial Setup
If you skipped the initial setup wizard, for example on
first-time use, you can reaccess it from here.
See "Initial Setup"
Note
• This setting cannot be selected if the "Monitor Out" setting
is set to "Sub".
22).
(➔ page 22).
En-73
Advanced Operations

8. Remote Controller Setup

Remote ID
■
Remote ID
1, 2, or 3
When several Onkyo components are used in the
same room, their remote ID codes may overlap. To
differentiate the AV receiver from other components,
you can change its remote ID from "1", to "2" or "3".
Note
• If you do change the AV receiver's remote ID, be sure to
change the remote controller to the same ID (see below),
otherwise, you won't be able to control it with the remote
controller.
Changing the remote controller's ID
1
While holding down RECEIVER, press and
hold down Q SETUP until the remote indicator
lights (about 3 seconds).
2
Use the number buttons to enter ID 1, 2, or 3.
The remote indicator flashes twice.
Remote Mode Setup
See "Looking up for Remote Control Codes"
(➔ page 76).

9. Lock Setup

With this preference, you can protect your settings by
locking the setup menus.
■
Setup
Locked
Unlocked
When "Locked" is selected, the setup menus will be
locked and you cannot change any setting.
Operating
procedure
(➔ page 56)