Remote Control Codes For Onkyo Components Connected Via U; Resetting Remote Mode Buttons; Resetting The Remote Controller; Controlling Other Components - Onkyo HT-R990 Instruction Manual

Remote Control Codes for Onkyo
Components Connected via u
Onkyo components that are connected via u are
controlled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.
1
Make sure the Onkyo component is connected with
an u cable and an analog audio cable (RCA).
See "Connecting Onkyo u Components" for details
(➔ page 19).
2
Enter the appropriate remote control code for
REMOTE MODE, referring to the previous
section.
42157:
Onkyo cassette tape deck with u
81993:
Onkyo Dock with u
3 Press REMOTE MODE, point the remote
controller at the AV receiver, and operate the
component.
Controlling Onkyo components without u
If you want to control an Onkyo component by pointing
the remote controller directly at it, or you want to control
an Onkyo component that's not connected via u, use the
following remote control codes:
30627:
Onkyo DVD player without u
71817:
Onkyo CD player without u
32900/33100/33500:
Onkyo Blu-ray Disc player
32901/33104/33504:
Onkyo HD DVD player
70868:
Onkyo MD recorder without u
71323:
Onkyo CD recorder without u
82990:
Onkyo Dock without u

Resetting REMOTE MODE Buttons

You can reset a REMOTE MODE to its default remote
control code.
1
While holding down REMOTE MODE that you
want to reset, press and hold down HOME until the
remote indicator lights (about 3 seconds).
2 Within 30 seconds, press REMOTE MODE again.
The remote indicator flashes twice, indicating that the
button has been reset.
Each of REMOTE MODE is preprogrammed with a
remote control code. When a button is reset, its
preprogrammed code is restored.
Downloaded from www.Manualslib.com manuals search engine

Resetting the Remote Controller

You can reset the remote controller to its default settings.
1
While holding down RECEIVER, press and hold
down HOME until the remote indicator lights
(about 3 seconds).
2 Within 30 seconds, press RECEIVER again.
The remote indicator flashes twice, indicating that the
remote controller has been reset.

Controlling Other Components

By pressing the REMOTE MODE that's been
programmed with the remote control code for your
component, you can control your component as described
below.
For details on entering a remote control code for other
components, see "Entering Remote Control Codes"
page 64).
(➔
Controlling a TV
TV is preprogrammed with the remote control code for
controlling a TV that supports the p
some models). The TV must be able to receive remote
control commands via p and be connected to the
AV receiver via HDMI. If controlling your TV via
p doesn't work very well, program your TV's
remote control code into TV and use the TV remote mode
to control your TV.
Use the following remote control codes:
11807/13100/13500:
TV with p
Controlling a Blu-ray Disc/DVD Player, HD
DVD Player or DVD Recorder
BD/DVD is preprogrammed with the remote control code
for controlling a component that supports the p
(limited to some models). The component must be able to
receive remote control commands via p and be
connected to the AV receiver via HDMI.
Use the following remote control codes:
32910/33101/33501/31612:
Blu-ray Disc/DVD player with p
The p supported by the
*1
system control function of the HDMI standard.
(limited to
*1
*1
is the CEC
AV receiver
En
65