Co Line Call Limitation - Panasonic KX-TDA100 Feature Manual

1.3 C

1.3.15 CO Line Call Limitation

Description
CO line calls are limited by the following features:
Feature
Extension-to-CO Line Call
Duration
CO-to-CO Line Call (except
Unattended Conference Call)
Duration
Dialing Digit Restriction during
Conversation
Conditions
• During an Unattended Conference Call, the Unattended Conference Recall time is applied. (→ 1.3.16
Conference)
• When using LCO lines that do not support Calling Party Control (CPC) signal detection (→ 1.3.20 CPC
(Calling Party Control) Signal Detection), the CO-to-CO Line Call Duration timer should not be disabled,
as automatic end of call detection cannot be performed.
Programming References
PC Programming Manual
2.8.11 [2-7-1] Class of Service—COS Settings—TRS—Extension-CO Line Call Duration Limit
2.8.17 [2-9] System Options—Option 2—Extension - CO Call Limitation—For Incoming Call
2.9.1 [3-1-1] Trunk Group—TRG Settings—Main
→ CO-CO Duration Time
→ Extension-CO Duration Time
2.13.5 [7-5] Miscellaneous—Dial Digits Limitation After Answering—Dial Digits
PT Programming Manual
[472] Extension-to-CO Line Call Duration
[473] CO-to-CO Line Call Duration
[502] CO Line Call Duration Limitation
58 Feature Manual
If a call between an extension user and an outside party is established,
the call duration can be restricted by the system timer selected for
each trunk group. Both parties will hear warning tones at five-second
intervals starting 15 seconds before the time limit. When the time limit
expires, the line will be disconnected. COS programming determines
whether this feature is enabled or disabled. Whether this feature
applies to outgoing calls only, or to both outgoing and incoming calls
is determined through system programming.
If a call between two outside parties is established, the call duration
can be restricted by the system timer selected for each trunk group.
Both parties will hear warning tones at five-second intervals starting 15
seconds before the time limit. When the time limit expires, the line will
be disconnected.
If both parties involved in the CO-to-CO line call were established by
an extension (e.g., an extension makes a CO line call, then transfers
the call to an outside party), the time limit applied to the CO line call
that was made first will be used.
While engaged in an incoming CO line call, the dialing of digits can be
restricted. If the number of dialed digits exceeds the limitation, the line
will be disconnected.
Description