Panasonic KX-TDA100 Feature Manual page 245

maximum, the data is discarded. This is used to prevent data from circling unnecessarily around the
network.
→ 2.15.2 [9-2] Network Data Transmission—Network BLF Data Transmission for Centralized Operator
Feature—Data Transmission Counter
• If it is not possible to remotely turn off transmission of extension status information using the NDSS
Monitor Release feature because of network conditions, it is possible to perform the same operation
directly through system programming at the monitored PBX.
→ 2.10.8 [4-1-6] Wired Extension—NDSS Link Data - Send
→ 2.10.15 [4-2-4] Portable Station—NDSS Link Data - Send
• When using a VoIP network, if extension status information is lost by the network, in some cases an
NDSS button may not be able to display the status of the relevant extension.
• NDSS can not be used when two PBXs are networked using the [TIE Call by Own PBX Extension
Number] feature (→ 1.13.13 PRIVATE NETWORK FEATURES).
Programming References
PC Programming Manual
2.7.14 [1-1] Slot—PRI Port (KX-TDA100/KX-TDA200/KX-TDA600 only)—CO Setting—Networking Data
Transfer
2.8.11 [2-7-1] Class of Service—COS Settings—Extension Feature—Manager
2.10.5 [4-1-4] Wired Extension—Flexible Button
→ Type
→ Dial (for NDSS)
2.10.8 [4-1-6] Wired Extension—NDSS Link Data - Send
2.10.13 [4-2-3] Portable Station—Flexible Button
→ Type
→ Dial (for NDSS)
2.10.15 [4-2-4] Portable Station—NDSS Link Data - Send
2.10.17 [4-3] DSS Console—Flexible Button
→ Type
→ Dial (for NDSS)
2.15.2 [9-2] Network Data Transmission
2.15.3 [9-3] Network Operator (VoIP)
2.15.4 [9-4] NDSS Key Table
PT Programming Manual
[511] Manager Assignment
Feature Manual References
1.13.13 PRIVATE NETWORK FEATURES
1.13.18 PRIVATE NETWORK FEATURES—QSIG
1.13.23 Private Network Features—VoIP (Voice over Internet Protocol)
Operating Manual References
1.2.1 Making Calls
2.1.4 Private Network Features—NDSS (Network Direct Station Selection) Monitor Release
1.13 P
Feature Manual 245