Table of Contents
Advertisement
Lamps
Replacing Lamps
A-61159 May 2002
The scanner has a lamp saver feature to prolong lamp life. The lamps
shut off after 10 minutes of scanner idle time. Do not mistakenly replace
lamps that are off due to the lamp saver mode.
IMPORTANT: If you disable the lamp saver feature, your lamps will
wear out more quickly.
There are two identical lamps in the scanner. The procedure below
shows how to replace the lamp behind the side access door. Use the
same procedure to replace the lamp in the pod.
NOTE: To order lamps, refer to Appendix B, Supplies.
CAUTION:Lamps that have been operating are HOT. Make sure
that the lamp has cooled before you replace it.
1. Follow all of the steps in "Lowering the Pod" in this chapter.
2. Open the side access door.
CAUTION:Make sure that the scanner is turned off, and allow
it to cool for 10 minutes before attempting to replace
the lamp.
5-21
Advertisement
Table of Contents
