Install The Gun Onto The Manifold And Mounting Bracket - Graco PRO AA5500SC Instruction Manual

Install the Gun onto the Manifold and
Mounting Bracket
1. Remove the retaining nut (1), tip guard, (12), air
cap (15), spray tip (13), and gun shroud (2). See
Fig. 46.
2. Make sure the gaskets (108, 121) and spring (105)
are in place on the manifold (101). Inspect the
parts for damage and replace them as needed.
3. Secure the gun (B) to the manifold (101) by tight-
ening the three screws (106) with the ball end
wrench (77–not shown).
1, 12, 13, 15
Fig. 46
Service
B
2
4. Connect the fluid hose to the fluid inlet fitting
(3–marked P1 on the manifold). Use an open end
wrench to hold the fluid fitting hex and prevent it
from turning.
5. Secure the gun (B) to the mounting bracket (102)
by tightening the screw (21) with the ball end
wrench (77).
6. Slide the shroud (2) over the gun.
7. Install the spray tip (13), air cap (15), tip guard
(12), and retaining nut (1) as instructed on page
32. Tighten the retaining nut firmly.
121
108
105
21
106
101
102
3
308387
03626
41