Optional Fiber Optic Cable Connection; Optional Fiber Optic Lens Kit Installation - Graco PRO AA5500SC Instruction Manual

Optional Fiber Optic Cable Connection

An optional fiber optic fitting (37) is shipped unas-
sembled with the gun. If an ES (kV) display module is
used, install the fitting in the manifold. See Fig. 2, page
8, for a schematic of the fiber optic connections.
1. Remove the 1/8 npt plug (115) from the manifold's
fiber optic port, and install the black fiber optic
fitting (37). See Fig. 6.
37
115
Fig. 6
2. Remove the nut (QQ) from the fiber optic fitting
(37), and slide the nut over the end of the fiber
optic cable (RR). See Fig. 7.
3. Insert the cable (RR) into the fitting (37), and push
the cable in until it bottoms out. Tighten the nut
(QQ) to secure the cable.
37
QQ
RR
Fig. 7
4. If you have two bulkhead splices in your system, it
is recommended that you install the fiber optic lens
kit, as described at right.
NOTE: Most of the fiber optic light transmission loss
occurs at the bulkhead splices. For the strongest light
signals, use a minimum number of bulkhead splices. A
maximum of two splices, with a total of 108 feet (32.94
m) of cable, is recommended.
5. See manual 308265 to install a Graco ES Display
Module.
12 308387
Installation

Optional Fiber Optic Lens Kit Installation

NOTE: The fiber optic lens kit is not included with the
gun. Order it separately; the part number is 236852.
1. Remove the gun from the manifold as instructed
on page 30.
2. Make sure the lens (TT) is clean. Push the lens
into the counterbore (VV) in the manifold fiber optic
port (SS). See Fig. 8 and 9.
3. Press the lens retainer (UU) into the manifold fiber
optic port (SS) until it is flush with the manifold
surface.
4. Assemble the gun to the manifold as instructed on
03620
page 41.
UU
Fig. 8
03509A
Fig. 9
SS
TT
TT
UU
SS VV
04798
04485