Four Slot Ethernet Cradle - Motorola MC7090CN User Manual

Four Slot Ethernet Cradle

Troubleshooting the Four Slot Ethernet Cradle
Table 5-4
Symptom
Attempt by the EDA
to ActiveSync failed.
During
communication, no
data transmits, or
transmitted data was
incomplete.
Cause
EDA removed from Wait one minute and reinsert the EDA in the cradle. This
the cradle while the allows the cradle to attempt another synchronization.
LED was blinking
green.
Using an outdated Visit
version of software.
ActiveSync.
ActiveSync on the Wait one minute and reinsert the EDA in the cradle. This
host computer has allows the cradle to attempt another synchronization.
not yet closed the
previous ActiveSync
session.
Incorrect cable Ensure the correct cable (Ethernet) is used with the cradle.
configuration.
Communication Perform setup as described in the MC70 Integrator Guide.
software improperly
configured.
EDA ActiveSync On the EDA, tap Start - ActiveSync - Tools - Options - Options
disabled or not button. Then, uncheck the Enable PC sync using this
configured to accept connection: check box.
network connection.
Host ActiveSync On the host computer, check File - Connection Settings - Allow
disabled or not network (Ethernet) Server Connection with this desktop
configured to accept computer.
network connection.
EDA removed from Replace EDA in cradle and retransmit.
cradle during
communications.
EDA has no active An icon is visible in the status bar if a connection is currently
connection. active.
Maintenance & Troubleshooting
Solution
http://www.microsoft.com for the latest ActiveSync
5 - 7