Table of Contents
Advertisement
O
PERATION
Fan Mode
This setting determines how the fan speed on the STRIKE 1 is set.
1.
Go to the Fan Mode main level
2.
Select Auto (fan speed will increase or decrease based on product temperature) or On (fan
speed will always be at maximum).
Back Light
This setting allows for selection of the amount of time the backlight on the STRIKE 1's display stays on
after the last button is pressed on the control panel.
1.
Go to the Back Light main level.
2.
Select On (remains on), 10S (10 seconds), 20S (20 seconds), or 30S (seconds).
System Information
This option displays the total number of hours the product has run, the installed software version, and the
product's UID.
1.
Go to the Information main level.
2.
Select Fixture Hours, Version, or UID.
Factory Reset
This option restores the STRIKE 1 to factory default settings.
1.
Go to the Reset Factory main level.
2.
Select No or Yes.
STRIKE 1 User Manual Rev. 2
Page 13 of 17
Advertisement
Table of Contents
