Stick Scratch Start - Miller TRAILBLAZER 302 AIR PAK Owner's Manual

Switch Setting
Electrode Hot − Wire
Electrode Hot − Stick
Electrode Hot − Stick
Electrode Hot − Lift Arc w/Auto-Crater
Electrode Hot − Lift Arc w/Auto-Stop
TIG − Remote On/Off
Stick − Remote On/Off
Wire − Wire Feeder (CV) Using
Remote
6-5.

Stick Scratch Start

Process/Contactor Switch Settings
Process
MIG (GMAW)
Stick (SMAW)
Select Preferred Dig
Air Carbon Arc (CAC-A) Cutting And Gouging
Select Any Dig
TIG (GTAW) Lift Arc w/Auto-Crater (GTAW) (DC Only)
TIG (GTAW) Lift Arc w/Auto-Stop (GTAW) (DC Only)
GTAW With HF Unit, Pulsing Device, Or
Remote Control (AC or DC)
Stick (SMAW) With Remote On/Off
MIG (GMAW)
1
2
3
Output On/Off Control
Electrode Hot
Electrode Hot
Electrode Hot
Electrode Hot
Electrode Hot
At Remote Receptacle
At Remote Receptacle
At Remote Receptacle
With Stick selected, start arc as
follows:
1 Electrode
2 Workpiece
3 Arc
Drag electrode across workpiece like
striking a match; lift electrode slightly
after touching work. If arc goes out
electrode was lifted to high. If
electrode sticks to workpiece, use a
quick twist to free it.
OM-229 930 Page 33