Section 5 − Installation; Serial Number And Rating Label Location; Installing Welding Generator - Miller TRAILBLAZER 302 AIR PAK Owner's Manual

5-1. Serial Number And Rating Label Location

The serial number and rating information for this product is located on the rear panel. Use rating label to determine rated output. For future reference,
write serial number in space provided on back cover of this manual.

5-2. Installing Welding Generator

Movement
Location / Airflow Clearance
18 in.
(460 mm)
18 in.
(460 mm)
18 in.
(460 mm)
Mounting
OM-229 930 Page 22
SECTION 5 − INSTALLATION
OR
OR
18 in.
(460 mm)
18 in.
(460 mm)
1
!
Do not move or operate unit
where it could tip.
!
Do not lift unit from end.
!
Do not weld on base. Welding on
base can cause fuel tank fire or
explosion. Bolt unit down using
holes provided in base.
!
Always securely fasten welding
generator onto transport vehicle
or trailer and comply with all DOT
and other applicable codes.
NOTICE − Do not install unit where air
flow is restricted or engine may over-
heat.
.
See Section 4-4 for lifting eye rating.
Mounting:
!
Do not mount unit by supporting
the base only at the four mount-
ing holes. Do not use flexible
mounts. Use cross-supports to
adequately support unit and pre-
vent damage to base.
1 Cross-Supports
Mount unit on flat surface or use cross-
supports to support base.
install2 2008-01 − Ref. 800 652 / Ref. 800 477-A / 803 274-A / 804 712