Kenwood DDX9016S Instruction Manual page 67

REMOTE CONTROLLER
Using the steering remote
controller
You can assign functions to the keys of the remote
controller on the steering wheel.
• This function is available only when your vehicle
is equipped with the electrical steering remote
controller.
• You can only register/change the functions while
you are parked.
• If your steering remote controller is not
compatible, learning may not be completed and
an error message may appear.
❏ Registering/changing the functions
1
Display the source/option selection screen.
On the Home screen or the source control
screen:
2
Display the <SETUP> screen.
3
Display the <User Interface> screen.
• Scroll the page to show more items.
4
Display the <Steering Remote Controller
Setting> screen.
5
When the unit is ready for learning, press
and hold a steering remote controller
button for about 2 seconds to register/
change.
• Refer to the message displayed to confirm
whether the unit ready before proceeding.
6
Select a function to assign.
• Scroll the page to show more items.
• To close the window, touch [Close].
7
Repeat steps 5 and 6 as necessary.
8
Finish the procedure.
• The unit can register/change all of the buttons'
functions at the same time. To do this, press each
button in turn and after pressing all of them, touch
[Done] on the <Steering Remote Controller
Setting> screen. However, new functions cannot
be learned after this operation.
• When changing the functions already learned,
touch the button you want to change in step 5
and then touch to select the new function from
the function list.
• Confirm the contents of the settable functions in
the function list. You cannot edit the function list.
❏ Initializing the settings
1
Display the <Steering Remote Controller
Setting> screen. (See the far left column.)
2
A confirmation message appears. Touch [Yes].
ENGLISH 67