Radio - Kenwood DDX9016S Instruction Manual

Radio

Listening to the radio
❏ Indications and buttons on the source
control screen
1 2 3 4
6 7 8 9 p q
Radio reception information
1 Preset no.
2 Current band
3 Frequency/PS name
4 Seek mode (See the right column.)
5 Preset list (Page 28)
6 Standby reception indicators (Page 29)
7 AF indicator (Page 30)
8 LO.S indicator (Page 28)
9 ST/MONO indicator: Lights up when receiving
an FM stereo broadcast with sufficient signal
strength.
p RDS indicator: Lights up when receiving a Radio
Data System station.
q EON indicator: Lights up when a Radio Data
System station is sending EON signals.
Operation buttons
[AUTO1]/ Changes the seek mode. Each time
[AUTO2]/
you touch the button, the seek mode
[MANUAL] changes as follows:
• AUTO1: Auto search
5
• AUTO2: Tunes in stations in the
memory one after another.
• MANUAL: Manual search
[FM]
Selects the FM band (FM1 – FM3).
[AM] Selects the AM band.
[TI]* Activates/deactivates TI standby
reception mode. (Page 29)
[MONO] Activates/deactivates monaural mode
for better FM reception. (Stereo effect
will be lost.)
• The MONO indicator lights up while
monaural mode is activated.
[PTY]*
Enters PTY search mode. (Page 29)
[ ] Mutes the sound.
• To restore the sound, touch the
button again, or adjust the volume.
[S] [T] Searches for a station.
• The search method differs
according to the selected seek
mode. (See above.)
[AME] Presets stations automatically.
(Page 28)
[ ] Changes the settings for radio
reception on the <Radio SETUP>
screen. (Pages 27 – 30)
* Appears only when FM is selected as the band.
❏ Setting the antenna control
You can store the antenna automatically when the
source is changed from the tuner to another source.
• The antenna is extended regardless of the setting
when the source is the tuner.
1
Display the <Radio SETUP> screen.
2
[ON]
Select this to keep the antenna
extended even when the source is not
the tuner.
[OFF] Select this to store the antenna
automatically.
ENGLISH 27