Kenwood DDX9016S Instruction Manual page 54

SETTINGS
❏ Using the sound equalization
• The adjustment is memorized for each source until
you adjust the sound again. If the source is a disc,
the adjustment is stored for each of the following
categories.
– DVD-Video
– CD/VCD/Audio files/Video files (Page 79)
• You cannot adjust the sound when the unit is in
standby.
Selecting a preset sound mode
1
Display the <Audio> screen. (Page 53)
2
Display the <Graphic Equalizer> screen.
3
Display the preset sound modes (1), then
select a sound mode (2).
• Touch [ ] to hide the preset sound modes.
54
Storing your own adjustments—Adjusting the
sound precisely
1
Display the <Graphic Equalizer> screen.
(See the left column.)
2
Select a band and adjust the level of the
selected band.
• You can adjust the level by dragging the slider
or using [J]/[K].
• Repeat this step to adjust the level of other
bands.
3
Activate ([ON]) or deactivate ([OFF]) the
bass (<Bass EXT>) (1), and then adjust
the subwoofer level (<SW Level>)* (2).
• Touch [H]/[I] to adjust <SW Level>.
• When <Bass Ext> is set to [ON], a frequency
lower than 62.5 Hz is set to the same gain
level as 62.5 Hz.
4
Store the adjustment.
A user selection window appears. Select from
[User 1] to [User 4] to store your adjustment,
then touch [Close] to close the window.
• To apply the adjusted equalizer to all playback
source, touch [ALL SRC] on the <Graphic
Equalizer> screen, then touch [OK] to confirm.
• To make the current EQ curve flat, touch
[Initialize].
* Not adjustable when <None> is selected for subwoofer on the
<Speaker Select> screen. (Page 53)
❏ Setting the crossover network
mode (Only for DDX9016S Region 3/
DDX916WS Region 3)
Select the appropriate crossover network mode
according to the speaker system (2-way speaker
system or 3-way speaker system).
1
Put the unit in standby. (Page 9)
2
K
Press and hold volume while holding
M
on the monitor panel to display the
<X'over Network> screen.
3
Select the crossover network mode.
[2 way] Select this when connecting speakers
in a 2-way system (front/rear).
[3 way] Select this when connecting speakers
in a 3-way system (tweeter/mid
range/woofer).
A confirmation message appears. Press [Yes].