Coolant - Yamaha FAZER FZS600 Owner's Manual

CAUTION:
@
If the oil level warning light flickers
or remains on, immediately turn the
engine off and have a Yamaha deal-
er check the vehicle.
@
10. Turn the engine off, and then
check the oil level and correct it if
necessary.
PERIODIC MAINTENANCE AND MINOR REPAIR
EC000067
1. Coolant reservoir
2. Maximum level mark
3. Minimum level mark

Coolant

To check the coolant level
1. Place the motorcycle on a level
surface and hold it in an upright
position.
NOTE:
@
The coolant level must be checked
on a cold engine since the level
varies with engine temperature.
Make sure that the motorcycle is po-
sitioned straight up when checking
the coolant level. A slight tilt to the
side can result in a false reading.
@
6-12
2. Remove panel A. (See page 6-5
for panel removal and installation
procedures.)
3. Check the coolant level in the
coolant reservoir.
NOTE:
@
The coolant should be between the
minimum and maximum level marks.
@
4. If the coolant is at or below the
minimum level mark, open the res-
ervoir cap, add coolant to the max-
EAU01718
imum level mark, and then close
the reservoir cap.
Coolant reservoir capacity:
0.61 L
6