Speedometer Unit - Yamaha FAZER FZS600 Owner's Manual

Fuel level warning light "
This warning light comes on when the
fuel level drops below approximately
3.5 L. When this occurs, refuel as soon
as possible.
The electrical circuit of the warning light
can be checked according to the fol-
lowing procedure.
1. Set the engine stop switch to "
and turn the key to "ON".
2. Shift the transmission into the neu-
tral position or pull the clutch lever.
3. Push the start switch. If the warn-
ing light does not come on, have a
Yamaha dealer check the electri-
cal circuit.
NOTE:
@
This model is equipped with a self-di-
agnosis device for the fuel level warn-
ing light circuit. (See page 3-5 for an
explanation of the self-diagnosis
device.)
@
INSTRUMENT AND CONTROL FUNCTIONS
EAU03509
"
"
1. Speedometer
2. Odometer/tripmeter/clock
3. "SELECT" button
4. "RESET" button

Speedometer unit

This speedometer unit is equipped with:
an odometer
two tripmeters
a clock
Odometer and tripmeter modes
When set to "ODO", the motorcycle's
total mileage is indicated.
When set to "TRIP 1" or "TRIP 2", the
motorcycle's mileage since the tripme-
ter was last reset is indicated. Use the
tripmeters to estimate how far you can
ride on a tank of fuel. This information
will enable you to plan fuel stops in the
future.
To select a mode
Push the "SELECT" button to change
between the odometer mode "ODO" ,
the tripmeter modes "TRIP 1" and
"TRIP 2", and the clock mode in the fol-
lowing order:
"ODO" → "TRIP 1" → "TRIP 2" →
Clock → "ODO"
EAU03028*
To reset a meter
To reset either tripmeter 1 or 2 to 0.0,
select either by pushing the "SELECT"
button and push the "RESET" button
for at least one second.
Clock mode
To change the display to the clock
mode, push both the "SELECT" and
"RESET" buttons.
To change the display back to the
odometer mode, push the "SELECT"
button.
3-4
3