Coolant - Yamaha FJR1300AE 2023 Owner's Manual

Periodic maintenance and adjustment
2
3
1. Final gear oil filler bolt
2. Gasket
3. Final gear oil drain bolt
4. Install the final gear oil drain bolt
and its new gasket, and then tight-
en the bolt to the specified torque.
Tightening torque:
Final gear oil drain bolt:
23 N·m (2.3 kgf·m, 17 lb·ft)
5. Refill with the recommended final
gear oil to the brim of the filler
hole.
Recommended final gear oil:
Yamaha genuine shaft drive gear oil
SAE 80W-90 API GL-5
Oil quantity:
0.20 L (0.21 US qt, 0.18 Imp.qt)
6. Check the oil filler bolt gasket for
damage, and replace it if neces-
sary.
7. Install the oil filler bolt and its gas-
ket, and then tighten the bolt to
the specified torque.
Tightening torque:
Final gear oil filler bolt:
23 N·m (2.3 kgf·m, 17 lb·ft)
8. Check the final gear case for oil
leakage. If oil is leaking, check for
the cause.

Coolant

The coolant level should be checked
regularly. In addition, the coolant must
1
be changed at the intervals specified in
the periodic maintenance chart.
2
Recommended coolant:
YAMALUBE coolant
Coolant quantity:
Coolant reservoir (max level mark):
0.25 L (0.26 US qt, 0.22 Imp.qt)
Radiator (including all routes):
2.60 L (2.75 US qt, 2.29 Imp.qt)
TIP
If genuine Yamaha coolant is not avail-
able, use an ethylene glycol antifreeze
containing corrosion inhibitors for alu-
minum engines and mix with distilled
water at a 1:1 ratio.
To check the coolant level
1. Wait for the engine to cool. The
coolant level will vary with engine
temperature.
2. Place the vehicle on the center-
stand.
3. Remove the left cowling vent pan-
el. (See page 4-36.)
4. Look at the coolant reservoir.
1
1. Coolant reservoir
2. Maximum level mark
3. Minimum level mark
7-16
EAUS1203
7
EAU54164
2
3