Replacing A Turn Signal Light Bulb; Front Wheel - Yamaha FAZER FZS600 Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
1. Screw
Replacing a turn signal light
bulb
1. Remove the turn signal light lens
6 by removing the screw.
2. Remove the defective bulb by
pushing it in and turning it counter-
clockwise.
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screw.
1. Wheel axle
2. Front wheel axle pinch bolt
EAU01095

Front wheel

To remove the front wheel
WARNING
@
It is advisable to have a Yamaha
dealer service the wheel.
Securely support the motor-
cycle so that there is no danger
of it falling over.
@
1. Place the motorcycle on the cen-
terstand.
2. Loosen the front wheel axle pinch
bolt, then the wheel axle and the
brake caliper bolts.
1. Brake hose holder
2. Plastic fastener
3. Caliper bolt (× 2)
EAU03560
4. Speed sensor
3. Remove the brake hose holders
4. Remove the brake calipers by re-
EW000122
CAUTION:
@
Do not pull the brake lever after the
brake caliper has been removed,
otherwise the brake pads will be
forced shut.
@
6-39
by removing the bolts.
moving the bolts.
ECA00047