Deactivation; Programming - BMW C 650 GT Rider's Manual

Flashes 4x: Disconnection of
the anti-theft alarm from the
vehicle's battery
Information on alarm
triggering
If an alarm was triggered after
the last activation of the alarm
function, the rider is notified
accordingly by an alarm tone
sounding once when the ignition
is switched on.

Deactivation

with anti-theft alarm (DWA)
Deactivating alarm
function
Press button 1 on the remote
control once or switch on the
ignition with an authorised key.
OE
Note that you can deactiv-
ate the alarm function with
the ignition key only when the kill
switch is in the RUN position.
If the alarm function is de-
activated by the remote
control and the ignition is not
subsequently switched on, the
alarm function automatically goes
active again after 30 seconds if
"Activation after ignition OFF" is
programmed.
Turn indicators flash once.
Alarm tone sounds once (if
programmed).
Alarm function is deactivated.
Conserving battery power
Approximately one hour after the
alarm is armed, the receiver for
the remote control in the anti-
theft alarm shuts down in order
not to draw power unnecessar-
ily from the battery. If you want
to deactivate the alarm function
after the receiver has shut down
in this way, you have to switch
the ignition on.

Programming

with anti-theft alarm (DWA)
5
57
z
OE