Introduction - Toro groundsmaster 3240-d Operator's Manual

1.17

INTRODUCTION

The Toro Groundmaster 3240-D is a diesel engine powered self-propelled machine with hydraulic systems
for ground drive, cutterdeck drives and steering.
The machine can be operated in either two wheel or four wheel drive and a differential lock function may
be selected in four wheel drive.
The Toro Groundmaster 3240-D is a precision built machine designed solely for cutting grass and similar
low lying ground vegetation within the limitations stated in this manual. Use in any other way is consid-
ered as contrary to the intended use. Compliance with and strict adherence to the conditions of operation,
service and repair as specified in this Operators Manual also constitute essential elements of the intended
use. The way in which this machine is operated and maintained will have a profound effect on its per-
formance and reliability.
This manual contains advice on the Toro Groundmaster 3240-D which should be operated,serviced and
repaired only by persons who are familiar with its particular characteristics and who are acquainted with
the relevant safety procedures.
The safety precautions listed here in and all other generally recognised regulations on safety and all road
traffic regulations must be observed at all times.
Any arbitrary modifications carried out to this machine may relieve The Toro Company of liability for any
resulting damage or injury.
In the pursuit of continuous product development The Toro Company reserves the right to alter specifica-
tions without notice.
Cutterdecks: The Toro Groundmaster 3240-D is fitted with the following cutterdeck configuration:
Cutter Blade
Cutterdeck
Centre
L.H.
R.H.
Optional Extras:
Beacon Kit - Amber flashing warning light.
Lighting Kit - Complies with EC traffic regulations.
R.O.P.S ( Roll Over Protective Structure ) 2 post design.
Cab R.O.P.S. - Full weather protection and roll - over protection.
We recommend the fitting of a Hayter approved R.O.P.S only, to increase operator safety in the
event of a machine rolling over.
Note: With a R.O.P.S fitted stability angle is decreased to 11 degrees, due to the higher centre of
gravity of the machine.
Left and Right: Throughout this manual the terms 'Left' and 'Right' refer to the machine when
looking in the direction of forward travel.
INTRODUCTION
Number of
length cutter blades
560mm
560mm
560mm
Direction of Rotation
Viewed on Motor Shaft End
3
RH Blade - Clockwise
Middle Blade - Anti-clockwise
LH Blade - Anti-clockwise
2
Anti-clockwise
2
1.17
Clockwise