Fuel System Maintenance; Inspecting Fuel Lines And Connections; Replacing The Fuel Filter; Electrical System Maintenance - Toro 12004TC Operator's Manual

Fuel System
Maintenance
Inspecting Fuel Lines and
Connections
Check the fuel lines and connections every 400 operating
hours or yearly, whichever occurs first. Inspect them for
deterioration, damage, or loose connections.

Replacing the Fuel Filter

Replace the fuel filter every 800 operating hours or
yearly, whichever occurs first.
1. Raise the box and support it with the prop rod.
2. Place a clean container under the fuel filter.
3. Remove the clamps securing the fuel filter to the fuel
lines (Figure 37), as follows:
A. Squeeze the clamp tabs together and slide the
clamps up the hose off of the filter hose fittings.
B. Pull the hose ends off of the filter hose fittings.
Figure 37
1. Fuel filter
4. Install the replacement filter to the fuel lines with the
clamps previously removed.
Mount the filter so that the arrow points toward the
carburetor.
Electrical System
Maintenance

Replacing the Fuses

There are 3 fuses in the electrical system. They are
located beneath the bed in a box on the right hand side
of the frame (Figure 38).
Charge circuit
Lights
Power Point
Low oil light and hour meter
G002190
1. Charge circuit
2. Lights

Replacing the Headlights

Specification: GE #862
1. Set the parking brake, turn the ignition off, and
remove the key.
2. Switch the headlights off.
3. Reach beneath the dash and rotate the lamp assembly
1/4 turn counterclockwise (Figure 39).
31
10 amp. (15 amp. max.)
Figure 38
3. Power point
4. Low oil light and hour
meter
25 amp.
10 amp.
10 amp.