Toro 12004TC Operator's Manual page 40

9. Remove the spark plugs and check their condition;
refer to Changing Spark Plugs in Engine Maintenance
, page 28.
10. With the spark plugs removed from the engine, pour
two tablespoons of engine oil into the spark plug
hole.
11. Use the electric starter to crank the engine and
distribute the oil inside the cylinder.
12. Install the spark plugs and tighten to recommended
torque; refer to Changing Spark Plugs in Engine
Maintenance , page 28.
Note: Do not install the wire on the spark plug(s).
13. Remove the battery from the chassis, check the
electrolyte level, and charge it fully; refer to Servicing
the Battery in Electrical System Maintenance ,
page 31.
Note: Do not connect the battery cables to the
battery posts during storage.
Important: The battery must be fully charged
to prevent it from freezing and being damaged
at temperatures below 32°F (0°C). A fully
charged battery maintains its charge for about
50 days at temperatures lower than 40°F (4°C).
If the temperatures will be above 40°F (4°C),
check the water level in the battery and charge it
every 30 days.
14. Check and tighten all bolts, nuts, and screws. Repair
or replace any part that is damaged.
15. Paint all scratched or bare metal surfaces.
Paint is available from your Authorized Service
Dealer.
16. Store the machine in a clean, dry garage or storage
area.
17. Remove the ignition key and put it in a safe place out
of the reach of children.
18. Cover the machine to protect it and keep it clean.
40