Echo X7522340000 Safety Manual page 38

OPERATION
WARNING
Edger operation may scatter ground
debris that can cause unstable or slippery
footing, and increase the risk of slips and
falls. Always maintain proper footing and
balance while operating edger. Stop unit
if necessary, and remove excessive debris
from work path before continuing.
• ALWAYS maintain control using a secure, wrap-
around, two-handed grip when operating the
power edger. If the edger strikes a buried object,
it may kick up and out of the edging cut forcefully,
causing serious injury.
• NEVER operate with unit on left side of operator.
Use only on right side of body to keep operator out
of edger debris flow.
• ALWAYS maintain a stable, balanced stance, and
use extra care when walking on uneven, slippery,
or sloping surfaces.
• ALWAYS use extreme care when walking on
wet surfaces. Wet surfaces reduce traction, and
increase the risk of slips and falls.
• ALWAYS be aware of ground and walkway
conditions in the work area, and be prepared to
maintain balance and footing when conditions
change.
• ALWAYS check edging area for all potential
hazards before edging, and remove objects that
can be thrown or cause kick-out.
• NEVER edge where the cut line passes directly
over buried hazards such as sprinkler pipes,
electric wiring, gas lines, or other similar hazards.
• NEVER operate edger in any area where electric
extension cords are on the ground.
• NEVER use edger in gravel, rocky soil, or in areas with hard ground cover
such as decorative rocks.
• NEVER attempt to clear debris build-up from debris shield by tapping shield
against the ground.
• ALWAYS shut engine off, wait for blade to stop, and disconnect spark plug
wire. Remove debris with a small non-scratching scraper. Wear gloves to
protect hands from contact with sharp edges and hot surfaces.
38
Edger Operator in
Operating Position
Prohibition - Edger
Operation w/Electric
Cord on Ground
ENGINE
OFF
Debris Removal with
Scraper