Echo X7522340000 Safety Manual page 15

GT MAXI-CUT BLADE/NYLON LINE HEAD SET-UP GUIDE
TO USE
THESE
CUTTING
ATTACHMENTS
Front
Handle
Debris
You
Shield
must
Harness
install
these
parts!
Mounting
Hardware
*
Standard Cutting
Line Diameter
* All required installation hardware provided with cutting attachment
SRM Models:
If your trimmer-brushcutter requires assembly
before it can be used, you must make sure the
unit is properly configured for the type of cutting
attachment you will be using. Follow the instructions
in the Operator's Manual provided with the unit. You
must install the required cutting attachment, debris
shield, handle, and any other protective devices
needed, such as a harness loop and safety harness.
See SRM/PAS/SB Set-Up Guide Page 17)
If your trimmer-brushcutter has been preassembled,
you must make sure the unit is properly configured
for the type of cutting you will be performing. If the
unit is not properly configured, you must first remove
the incorrect parts, and then install the correct parts,
following the instructions in the Operator's Manual
before using the trimmer-brushcutter,
PAS/SB Models:
Pro Attachment Series (PAS) and Split-Boom
(SB) models are for use only with PAS series
attachments, and must not be used with any other
type or brand of attachment. Select the desired PAS
attachment, and assemble the attachment to the
powerhead driveshaft using the coupler. Follow the
safety and operating instructions in the Operator's
Manual provided with the attachment, and General
Safety Instructions in this Safety Manual.
GT Series
Maxi-Cut GT Dual
Grass/
Weed ECHOmatic
Plastic Line Head
Cutters
Flat
Extra
Washer
Hardware
3/8-24 R.H
Thread Hex
Required
Locknut
N/A
Diameter
GT Single
Line Line
ECHOmatic
Line Head
Loop Handle (STD)
Plastic Shield (STD)
Not Required
Extra
Hardware
Not Not
Required
.080 .080
Diameter
ASSEMBLY
2 Line
GT Rapid
Loader Line
Head
Flat Washer
3/8-24 R.H
Thread Hex
Locknut
.095
Diameter
SRM MODEL
Front
Handle
Debris
Shield
PAS MODEL
Front
Handle
15