Removal Of Inner Bowl; Removal Of Clutch Mechanism (Spline Drive / Spline Driven); Removal Of Selni Pump Hood & Cap - Fisher & Paykel SMARTDRIVE Service Manual

8.14 Removal of Inner Bowl

(a) Follow the procedure for removal of Neck Ring. (Refer to Section 8.12).
(b) Follow the procedure for removal of Agitator. (Refer to Section 8.13).
(c) Lift inner bowl upwards and clear of machine.
Note: If the inner bowl is tight on the shaft pressure may need to be placed on the top of
the shaft, while at the same time jiggling the inner bowl upwards.
Reassembly:
Refit in the reverse manner.
8.15 Removal of Clutch Mechanism (Spline Drive / Spline
Driven)
(a) Follow the procedure for removal of Inner
Bowl. (Refer to Section 8.14).
(b) Remove the 3 screws securing the spline
driven to the inner bowl.
Reassembly:
Refit in the reverse manner. Ensure that the
screws are tightened sufficiently with out over
tightening.
8.16 Removal of Selni Pump Hood & Cap
(a) Follow the procedure for removal of Inner
Bowl. (Refer to Section 8.14).
(b) Remove the bolt securing the pump hood to
outer bowl.
Reassembly:
Refit in the reverse manner. Ensure that the
gasket is not pinched between the pump hood
and outer bowl.
59
421827