Size Setting Mode; Quicksmart, Washsmart, Mw, Gw & Wa Size Setting - Fisher & Paykel SMARTDRIVE Service Manual

3.14.1 Scrud
If fabric softener is used regularly it will eventually cause a build up within the outer bowl. This can
result in black flakes present in the wash load that can stain garments. To remove scrud follow the
procedure below.
Step1: Add a full cup of a good quality dishwashing powder in to the machine.
Step 2: Set the machine to a Heavy Duty cycle, select a Hot Wash temperature, High Water level
and allow the machine to agitate for 10 minutes.
Step 3: Leaving the lid closed, turn the machine off and allow soaking overnight.
Step 4: The following day, turn the machine on and advance to the spin cycle to drain the water
from the machine. After the water has drained, turn the machine off then back on again, and select
a Heavy Duty cycle, Hot wash, High Water level, and allow the machine to complete a full cycle to
ensure that all of the loose scrud and residual detergent has been flushed away.
Note: If there is an extremely heavy build up the above procedure may have to be repeated.
If scrud residue is still present the removal of the inner bowl and cleaning manually
may be needed.
4

SIZE SETTING MODE

It is important to set the size switch setting into the Motor Controller's memory whenever a
replacement Motor Controller and or FabricSmart, IW Display Module is fitted to the machine.
Failure to do this will result in the machine faulting with fault code 9.
The size setting of the SmartDrive may be checked in the size setting mode.
4.1 QuickSmart, WashSmart, MW, GW & WA Size setting
Accessing size setting mode is the best way to check the set size of the machine.
To set the size switch, turn the power on at the supply point and off at the console. Press and hold
the WASH TEMPERATURE UP button then press the POWER button. The washer will give 4
short beeps and the pattern of LEDs will change.
One of the following buttons needs to be pushed to lock the size into memory.

Press WASH TEMP UP button, the COLD LED is on for 5.5kg (560mm wide).

Press WATER LEVEL UP button, the LOW WATER LED is on for 6.5kg / 7.0kg (600mm
wide).

Press SPIN SPEED UP button, the SPIN HOLD LED is on for 7.5 / 8.0kg (650mm wide).

Press POWER to confirm the setting and also exit this mode.
25
421827