Shaft & Bearing Replacement - Fisher & Paykel SMARTDRIVE Service Manual

421827
9.3 Shaft & Bearing Replacement
Procedures described in this section as well as section 9.4 can only be carried out by using the
Bearing Removal Tool Kit, part number 502009.
The contents of the kit are as follows:
Bearing Removal Tool Kit
502009
Note: The extractor mandrel was designed for the older shaft with the external thread,
however will work with the shaft on this machine with the internal thread.
(a) Follow the procedure for Removal of Outer Bowl from the Cabinet. (Refer to Section 8.18).
(b) Lay the outer bowl on its side before removal of the shaft. This ensures that the shaft does not
fall directly onto the floor.
Note: The shaft can only be removed towards the inside of the outer bowl. Remove the
shaft. If the shaft is difficult to remove, use a puller and a mandrel. Refit the thick Stator
motor clamp plate onto the outer bowl and secure with the four Stator mounting bolts. The
Stator clamp plate may be used to hold the legs of the puller in place.
66