Recycle Feature; Hot Bowl Flag; Fault Codes - Fisher & Paykel PHASE 7 INTUITIVE ECO IWL16-US Service Manual

517793A
4.5

Recycle Feature

In the Control Option mode (as for setting the RESTART feature), pushing the ADJUST button to
highlight the word RECYCLE will toggle this feature on and off. At the end of servicing, the
machine may require an extended test where the machine can be left to complete a number of
wash cycles. By turning on the RECYCLE feature the machine will continuously repeat the wash
cycle until the RECYCLE feature is turned off.
Whether or not the RECYCLE feature is on is indicated during normal use of the machine as
follows:
When the machine is first turned on:
1. If none of the FABRIC CARE LED's are on, the recycle feature is off.
2. If all of the FABRIC CARE LED's flash, the recycle feature is on.
NOTE: This feature is designed as a service aid only and should be OFF in the customer's
home. To return to normal operation, and to return the recycle feature to the factory
setting, switch the machine off at the wall or disconnect from the mains supply.
4.6

Hot Bowl Flag

If the machine has been filled with the hot water
valve utilized (ie. warm or hot fill) and has not
had a cold rinse, the electronics will not allow
the machine to spin up to its full speed of 1000
RPM. It will only allow the spin speed to reach
700 RPM.
To remove this flag, enter the Control Option
mode and push the OPTIONS UP button to take
the black shading out of the box
or put the machine through a complete final
rinse.
NOTE: The drain pump test, water valve test, restart, recycle and hot bowl flag features can
be accessed from any level in the diagnostic mode.
5

FAULT CODES

Fault codes for the Intuitive Eco™ washing machine are detailed in the master service manual, part
number 517792a.
Hot Bowl Flag,
11