Mounting The Lift Brackets And Chains - Toro 03698 Operator's Manual

1. Remove the locknut and the washer securing the pivot
rod to the number 2 lift arm
pivot rod and spring from the lift arm. Repeat the
procedure on the number 1 and number 3 lift arms.
1. Pivot rod
Note: The tipper bracket with the roller and the tipper
support brackets are not required when operating the
DPA cutting units
2. Disconnect the lift chains from the cutting units, if
attached.
3
Mounting the Lift Brackets and
Chains
Parts needed for this procedure:
5/7 Lift chain
5/7 Chain bracket
5/7 U-bolt
10/14 Nut
5/7 Screw
5/7 Washer
Nut
5/7
Procedure
Mount a chain bracket to each lift arm with a U-bolt and 2
nuts. Position the brackets as follows:
Note: Refer to
Figure 4
being described.
(Figure 3). Remove the
Figure 3
2. Tipper support bracket
w/roller
(Figure 3).
to determine the lift arm number
1. Cutting unit 1
2. Cutting unit 2
3. Cutting unit 3
4. Cutting unit 4
5. Cutting unit 5
1. On lift arm numbers 1, 4, and 5, position the chain
brackets and U-bolts 38.1 cm (15 inches) behind the
center line of the pivot knuckle
2. On lift arm numbers 1 and 5 the brackets should be
rotated to the right 10 degrees from vertical
3. On lift arm number 4 the bracket should be rotated to
the left 10 degrees from vertical
1
1. Lift arm number 5 =
38.1 cm (15 inches)
2. Lift arm number 4 =
10 degrees
4. On lift arm numbers 2 and 3, position the brackets and
U-bolts 38.1 cm (15 inches) behind the center line of
the pivot knuckle
Note: Rotate the brackets 45 degrees to the outboard
side of the machine.
5
Figure 4
6. Cutting unit 6
7. Cutting unit 7
8. Reel motor
9. Weight
(Figure 5).
(Figure 5).
2
3
g020546
Figure 5
3. Lift arm numbers 1 and 5 =
10 degrees
(Figure 6).
(Figure 5).