Figure 36
1. Angle-indicator mount
2. Edge of the magnet mated
with the edge of the
bedknife
4. Place the angle indicator on the mount as shown in
Figure
36.
Note: This is the angle that your grinder produces; it
should be within 2 degrees of the recommended top
grind angle.
3. Bedknife
4. Angle indicator
Servicing the Bedbar
Removing the Bedbar
1. Turn the bedbar-adjusting screws counterclockwise to
back the bedknife away from the reel
1. Bedbar-adjusting screw
2. Spring-tension nut
2. Back out the spring-tension nut until the washer is no
longer tensioned against the bedbar
3. On each side of the machine, loosen the locknut
securing the bedbar bolt
1. Bedbar bolt
4. Remove each bedbar bolt, allowing the bedbar to
be pulled downward and removed from the machine
bolt
(Figure
38). Account for 2 nylon washers and
1 stamped steel washer on each end of the bedbar
(Figure
39).
20
(Figure
Figure 37
3. Bedbar
4. Washer
(Figure
37).
(Figure
38).
Figure 38
2. Locknut
37).