Setup; Mounting The Castor Wheel; Mounting The Debris Blower To The Traction Unit - Toro 30393 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
Media and Additional Parts
Description
Parts Catalog
Operator's Manual
Note: Determine the left and right sides of the machine
from the normal operating position.
Note: To install and operate the debris blower, the
traction unit must be equipped with the Rear Quick
Attach System, Model 30377 and the Auxiliary Hydraulic
Power Kit, Model 30380.
1

Mounting the Castor Wheel

Parts needed for this procedure:
1 Castor wheel assembly
Procedure
1. Remove the tensioning cap from the castor wheel
spindle shaft (Figure 3). Slide the spacer and one
thrust washer off the spindle shaft. Leave one thrust
washer on the shaft.
Description
Castor wheel assembly
Debris blower assembly
Locking pin
Hair pin cotter
No parts required
No parts required
Qty.
1
1
1
1
–
–
Qty.
1
Read before operating.
1
1. Tensioning cap
2. Spacer
3. Thrust washer (2)
2. Push the castor spindle up through the bushings
in the blower frame, insert another thrust washer
onto the shaft, slide the spacer onto the spindle shaft
and install the tensioning cap to secure the assembly
(Figure 3).
3. Make sure the castor wheel assembly tire is inflated
to 35 to 50 psi.
6
Use
Mount the castor wheel to the debris
blower
Mount the debris blower to the traction
unit
Adjust the link assembly
Grease the blower
Use
Figure 3
4. Blower frame castor tube
5. Castor wheel