Table of Contents
Advertisement
2
Mounting the Debris Blower to
the Traction Unit
Parts needed for this procedure:
1
Debris blower assembly
1
Locking pin
1
Hair pin cotter
Procedure
1. Remove any attachment from the rear of the
machine.
2. Back the traction unit into position behind the
attachment adapter.
Note: Make sure the locking lever (Figure 4) is
pivoted to the left (unlocked position) as viewed
from the rear of the machine.
2
G003810
1. Attachment adapter
3. Raise the traction unit adapter into the attachment
adapter.
4. Pivot the locking lever to the right to lock the
adapters together.
1
Figure 4
2. Locking lever (locked
position)
5. Insert the locking pin through the adapters and
secure with a hairpin cotter (Figure 5).
1. Locking pin
6. Route the hoses through the hose support loop.
7. Remove the dust plugs from the hydraulic couplers
and make sure couplers are free of any dirt or
contamination.
8. Connect the attachment hydraulic hose couplers
to the hydraulic couplers on the traction unit rear
auxiliary hydraulic power kit.
Important: Whenever the hydraulic hose
couplers are disconnected, make sure the dust
plugs are cleaned and then installed to prevent
contamination from entering either hydraulic
system.
7
1
G006618
Figure 5
Advertisement
Table of Contents
