Motion Control Levers - Toro 74549 Operator's Manual

g015372
Figure 72
1. Switch screws
2. Cam
9. After the cam is adjusted, the lever switch needs to be
checked.
10. Check the gap between the control lever and switch
as shown in Figure 73. The gap needs to be an 1/8
inch (3mm) with the right motion control lever in the
neutral, unlocked position.
11. If needed, loosen the screws holding the switch and
adjust the switch (Figure 72 and Figure 73).
3. Nut and bolt
1 2
g015373
1. Switch
2. 1/8 inch (3mm)
12. Tighten the switch screws.
Adjusting the Neutral Postion for the

Motion Control Levers

Important: Ensure the tracking of the mower is correct
after adjusting the motion control levers. Adjusting the
tracking and aligning the motion control levers front to
back is the same procedure (Figure 74).
Note: Adjust the horizontal alignment before the front to
back alignment.
If the motion control levers do not align front to back, or the
right side control lever does not move easily into the neutral
lock position, adjustment is required.
1. After the horizontal alignment is finished, check the
front to back alignment (Figure 74).
48
3
2
Figure 73
3. Right motion control lever
in the neutral unlocked
position