Charging The Battery; Installing The Battery - Toro 74549 Operator's Manual

WARNING
Incorrect battery cable routing could damage the
machine and cables causing sparks. Sparks can
cause the battery gasses to explode, resulting in
personal injury.
• Always Disconnect the negative (black) battery
cable before disconnecting the positive (red)
cable.
• Always Reconnect the positive (red) battery
cable before reconnecting the negative (black)
cable.
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Lift the black rubber cover on the negative cable.
Disconnect the negative battery cable from the negative
(-) battery terminal (Figure 53).
4. Slide the red terminal boot off the positive (red) battery
terminal. Then remove the positive (red) battery cable
(Figure 53).
5. Remove the battery hold down plate (Figure 53) and
remove the battery.

Installing the Battery

1. Place the battery onto the machine (Figure 53).
2. Secure the battery with the hold down plate, j-bolts,
and locknuts.
3. First, install the positive (red) battery cable to positive
(+) battery terminal with a nut, washer and bolt
(Figure 53). Slide the rubber cover over the post.
4. Then install the negative battery cable and ground wire
to the negative (-) battery terminal with a nut, washer
and bolt (Figure 53). Slide the rubber cover over the
post.
1. Wing nut
2. Battery cover
3. Negative battery cable

Charging the Battery

WARNING
Charging the battery produces gasses that can
explode.
Never smoke near the battery and keep sparks and
flames away from battery.
Important: Always keep the battery fully charged
(1.265 specific gravity). This is especially important to
prevent battery damage when the temperature is below
32°F (0°C).
1. Remove the battery from the chassis; refer to Removing
the Battery.
2. Check the electrolyte level; refer to Checking the
Electrolyte Level.
3. Make sure the filler caps are installed in battery. Charge
battery for 1 hour at 25 to 30 amps or 6 hours at 4 to
6 amps.
4. When the battery is fully charged, unplug the charger
from the electrical outlet, then disconnect the charger
leads from the battery posts (Figure 54).
5. Install the battery onto the machine and connect the
battery cables, refer to Installing the Battery.
Note: Do not run the machine with the battery
disconnected, electrical damage may occur.
38
g018098
Figure 53
4. Positive battery cable
5. Battery