Checking The Tire Pressure - Toro 74549 Operator's Manual

Figure 57
1. Left cable adjustment
2. Cable lock
7. Check for proper tracking.
Note: If the machine will not start after adjusting
the tracking, make sure proximity switch target aligns
with bolt attached to motion control lever. Refer to
Adjusting the Proximity Switch (page 40).
8. Repeat the cable adjustment until the tracking is
correct.
9. Check that the machine does not creep from neutral
with the park brakes disengaged.
Important: Do Not rotate the linkage too far, as
this may cause the machine to creep in neutral.
10. Install the cable lock onto the cable adjusting nuts to
secure the adjustment (Figure 57).
Adjusting the Proximity Switch
Use this procedure if the machine will not start after adjusting
the tracking.
1. Check and ensure the bolt attached to the motion
control lever aligns with the proximity switch target
(Figure 58).
2. If needed, loosen the bolts and adjust the proximity
switch until the target aligns with bolt attached to the
motion control lever (Figure 58).
3. Check the distance of the bolt to the proximity switch.
It needs to be between 0.050 and 0.090 inches (1.27
to 2.29 mm) (Figure 58).
g017848
3. Right cable adjustment
4. If adjustment is needed, loosen the jam nut and adjust
the bolt to the correct distance. Tighten the jam nut
after adjusting the bolt (Figure 58).
5. Test the safety interlock system before operation.
1 6
2
1. Proximity switch target
2. Proximity switch
3. Bolts and nuts

Checking the Tire Pressure

Service Interval: Every 50 hours/Monthly (whichever
comes first)
Maintain the air pressure in the rear tires at 12-14 psi (83-97
kPa). Uneven tire pressure can cause an uneven cut.
Note: The front tires are semi-pneumatic tires and do not
require air pressure maintenance.
40
2 3 4
6
4
5
G015609
Figure 58
4. Bolt attached to the motion
control lever
5. Distance between 0.050
and 0.090 inches (1.27 to
2.29 mm) is needed
6. Jam nut