Storage; Cleaning And Storage - Toro 74568TE Operator's Manual

Storage

Cleaning and Storage

1. Disengage the power take off (PTO), set the parking
brake, turn the ignition key to off, and remove the key.
2. Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially the
engine.
Important: You can wash the machine with a mild
detergent and water. Do not pressure wash the
machine. Avoid excessive use of water, especially
near the drive system and engine. Pressure
washing can force dirt and water into critical parts,
such as spindle bearings and electrical switches.
3. Clean dirt and chaff from the outside of the engine
cylinder head fins and blower housing.
4. Check the brake; refer to
5. Service the air cleaner; refer to
Cleaner (page 34).
6. Grease the machine; refer to
(page 32).
7. Change the engine oil; refer to
Oil (page 36).
8. Check the tire pressure; refer to
Pressure (page 43).
9. For long-term storage:
A. Add stabilizer/conditioner additive to fuel in the
tank.
B. Run engine to distribute conditioned fuel through
the fuel system (5 minutes).
C. Stop engine, allow to cool and drain the fuel tank;
refer to Servicing the Fuel Tank in , or operate
engine until it stops.
D. Restart engine and run until it stops. Repeat, on
Choke until engine will not restart.
E. Dispose of fuel properly. Recycle as per local
codes.
Note: Do not store stabilizer/conditioned
gasoline over 90 days.
10. Remove the spark plug(s) and check its condition; refer
to Servicing the Spark Plug (page
plug(s) removed from the engine, pour two tablespoons
of engine oil into the spark plug hole. Now use the
starter to crank the engine and distribute the oil inside
the cylinder. Install the spark plug(s). Do not install the
wire on the spark plug(s).
11. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged or defective.
12. Paint all scratched or bare metal surfaces. Paint is
available from your Authorized Service Dealer.
Servicing the Brake (page
Servicing the Air
Lubricating the Machine
Changing the Engine
Checking the Tire
37). With the spark
13. Store the machine in a clean, dry garage or storage area.
Remove the key from the ignition switch and keep it
in a memorable place. Cover the machine to protect
it and keep it clean.
45).
60