Hydraulic System Maintenance; Servicing The Hydraulic System - Toro 74568TE Operator's Manual

Figure 72
1. Left cable adjustment
2. Cable lock
g017848
3. Right cable adjustment
Hydraulic System
Maintenance
Servicing the Hydraulic
System
Hydraulic Oil Type: Toro
®
or Mobil 1 15W-50 synthetic motor oil.
Hydraulic System Oil Capacity: 2.0 L (67 oz)
Important: Use oil specified. Other fluids could cause
system damage.
Checking the Hydraulic Fluid
Service Interval: After the first 8 hours
Every 50 hours
Note: There are 2 ways to check the hydraulic oil; when the
oil is warm, or when the oil is cold. The baffle inside the tank
has 2 levels depending if the oil is warm or cold.
1. Position the machine on a level surface.
2. Disengage the power take off (PTO) and shut off the
engine.
3. Wait for all moving parts to stop before leaving the
operating position and then set the parking brake.
4. Clean the area around the cap and the filler neck of the
hydraulic tank (Figure
4
1. Cap
2. Baffle
5. Remove the cap from the filler neck
Note: Look inside to check the fluid level in the
reservoir.
6. Add fluid to the reservoir until it reaches the cold level
of the baffle.
7. Run the machine at low idle for 15 minutes to allow
any air to purge out of the system and warm the fluid;
refer to Starting and Stopping the Engine (page
51
® ™
HYPR-OIL 500 hydraulic oil
73).
1 3
2
G012005
Figure 73
3. Cold fluid level—full
4. Hot fluid level—full
(Figure 73).
20).