Controls System Maintenance; Adjusting The Motion-Control-Handle Positions - Toro 74568TE Operator's Manual

5
4
Figure 68
1. Hydraulic pumps
2. Idler pulley
3. Clutch pulley
6. Remove the pump-drive belt
7. Install the new belt around the clutch and the 2 pump
pulleys.
8. Install the spring onto the shoulder bolt and washer,
and connect it to the engine deck with the nut
68).
9. Lower the machine to the operating position.
10. Install the mower-deck belt.
6
1
2
3
G015402
4. Clutch retainer
5. Pump-drive belt
6. Shoulder bolt, nut, and
washer
(Figure 68).
(Figure
Controls System
Maintenance
Adjusting the
Motion-Control-Handle
Positions
Adjusting the Right Side Motion-Control
Lever
If the motion-control levers do not align horizontally, adjust
the right side motion-control lever.
Note: Adjust the horizontal alignment before the front to
back alignment.
1. Disengage the PTO, move the right side motion-control
lever to the neutral position, and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Push the right motion-control lever down out of the
neutral-locked position
4. Check if the right motion-control lever aligns
horizontally with the left motion-control lever
69).
1. Left motion-control lever
2. Right motion-control lever
in the neutral-locked
position
5. To adjust the right motion-control lever horizontally,
the cam needs to be adjusted.
6. Release the cushion from the rear of the machine.
7. Loosen the nut holding the cam
49
(Figure 69).
Figure 69
3. Check the horizontal
alignment here
4. Right motion-control lever
(Figure 70).
(Figure