Synergic Welding Mode - Lincoln Electric LINC FEED 37 Operator's Manual

B. Synergic Welding Mode (LF 38 only)
Description:
During Synergic welding, the wire feeder determines the optimal voltage characteristics based upon the selected wire
type and diameter. Only the wire feed speed needs to be regulated by the user. The user can then adjust the height of
the arc using the right knob. Once the arc height has been established, it will remain at the same level regardless of any
variation in the wire feed speed.
Set-Up:
While pressing the Prog
button, rotate the Left knob
and select from the
following:
Before welding (Pre-Set):
Pre-Set Wire Feed Speed
(Meters/Minute)
Adjust with left knob.
During welding (Actual):
These actual values are displayed for 5 seconds after the weld has stopped. Press ENTER (LF 38 Only) to recall these
values.
Actual Welding Current
(A)
Steel 80/20
Stainless 98/2
Metal Cored 98/2
Flux Cored 80/20
Flux Cored CO2
AlMg 100% Arg
AlSi 100% Arg
Innershield NR-211MP
Innershield NR-232
Innershield NR-400
Innershield NS-3M
While pressing the Prog
button, rotate the Right
knob and select the
appropriate wire
diameter:
0.8, 1.0, 1.2 mm
0.8, 1.0, 1.2 mm
1.2, 1.6 mm
1.2, 1.6 mm
1.2, 1.6 mm
1.2, 1.6 mm
1.2, 1.6 mm
1.7, 2.0 mm
1.8, 2.0 mm
2.0 mm
2.0 mm
A-5
Pre-Set Relative Arc Height
100% is the baseline. This
value is often referred to as
Trim. Adjust with the Right
knob to increase/decrease arc
height.
Actual Welding Voltage
(V)