Mounting The Feet; Mounting The Dn-V755 On A Rack - Denon DN-V755 Operating Instructions Manual

Mounting the Feet

Attach the feet to the bottom of the set at points approximately 20 mm from the edges (for
both sides). Remove the protective sheets from the bottom of the feet, and press on them
from the top with sufficient strength to attach them.
Note Once attached, the feet cannot be removed from the unit.
Note If intending to install the unit(s) in a rack, do not install the feet.
Turn the unit over,
and then attach the
feet approximately 20
mm from the corner
points of the unit

Mounting the DN-V755 on a Rack

The DN-V755 is of 1U size, allowing it to be mounted in EIA standard 19" racks.
Notes
There are different mounting kits for each of the following configurations:
•
Two DN-V755 units mounted in the 1U space of a 19" rack.
•
A single DN-V755 unit mounted in the 1U space of a 19" rack.
When mounting the DN-V755 on a rack, use guide rails or shelf boards, etc., on the rack side
to prevent weight from being applied to the front of the DN-V755. The fittings alone cannot
support the weight of the DN-V755 (2.5 kg).
Do not cover the top of the unit. Remember, heat is dispersed from the DN-V755's upper
surface.
Set up the installation environment carefully. For example, take care to protect the DN-V755
from heat from other devices. If necessary, use forced ventilation. The surrounding conditions
must meet the following specifications:
Operating temperature range:
Operating humidity range:
Storage temperature range:
Storage humidity range:
o
5 – 35 C
5 – 85%
o
-20 – 60 C
5 – 90%
11