IBM System x3400 M3 Types 7378 Installation And User Manual page 94

10. See the Problem Determination and Service Guide for cabling information, if
11. Close the drive bay EMC shield.
12. Close the bezel.
If you have other options to install or remove, do so now.
The simple-swap-drive backplate controls the IDs for the internal simple-swap drive
bays. The following table lists the IDs for the hard disk drives and backplate that
are connected to simple-swap models.
78
IBM System x3400 M3 Types 7378 and 7379: Installation and User's Guide
7. Touch the static-protective package that contains the drive to any unpainted
metal surface on the server; then, remove the drive from the package and
place it on a static-protective surface.
8. Align the drive assembly with the guide rails in the bay (the connector end of
the drive goes in first).
9. Press the drive assembly loops toward each other; then, carefully slide the
drive assembly into the drive bay until it stops and release the loops.
Note: Do not release the loops on the drive assembly until it is completely
seated.
needed.