IBM System x3400 M3 Types 7378 Installation And User Manual page 92

To install a hot-swap hard disk drive, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Remove the filler panel from one of the empty hot-swap bays.
3. Make sure that the drive handle is open; then, slide the hard disk drive into the
4. Push the drive handle in until it latches.
Notes:
1. When you turn on the server, check the hard disk drive status LEDs to verify
2. If the server is configured for RAID operation through an optional ServeRAID
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 98.
76
IBM System x3400 M3 Types 7378 and 7379: Installation and User's Guide
on page 29.
hot-swap bay.
that the hard disk drive is operating correctly.
If the amber hard disk drive status LED is lit continuously, that drive is faulty
and must be replaced. If the green hard disk drive activity LED is flashing, the
drive is being accessed.
adapter, you might have to reconfigure your disk arrays after you install hard
disk drives. See the ServeRAID documentation on the IBM ServeRAID Support
CD for additional information about RAID operation and complete instructions
for using ServeRAID Manager.