Lexmark x950 series User Manual page 51

Additional printer setup
6
From the Wireless Configuration dialog, select Guided Setup (Recommended).
Note: Choose Advanced Setup only if you want to customize your installation.
7
Temporarily connect a USB cable between the computer on the wireless network and the printer.
Note: After the printer is configured, the software will instruct you to disconnect the temporary USB cable
so you can print wirelessly.
8
Follow the instructions on the computer screen.
Note: For more information on allowing other computers on the network to use the wireless printer, see the
Networking Guide.
Installing the printer on a wireless network (Macintosh)
Note: Make sure to disconnect the Ethernet cable when installing the printer on a wireless network.
Prepare to configure the printer
1
Connect the power cord to the printer, then to a properly grounded electrical outlet, and then turn on the
printer.
2
Locate the printer MAC address.
a
From the printer control panel, navigate to:
> Reports >
or
> Reports > Network Setup Page
In the Standard Network Card section, look for UAA (MAC).
b
Note: You will need this information later.
> Network Setup Page >
51