Bypassing Points From The Keypad - Honeywell LYNX Touch 7000 Owner's Manual

Bypassing Points from the Keypad

What You Do
Press
Press
Enter your
passcode
Press
Press
Press
or
to scroll through a
list of all protected
points in the area.
Press
to toggle point
from ARMED or
DISARMED to
BYPASSED
Press
NOTES:
1. An error message occurs when anything other than a master passcode is
entered.
2. The LED next to the UP arrow is lit, which indicates a point is bypassed or a
special protection point is disarmed. If additional points are to be bypassed,
repeat the procedure.
3. Bypassed points are unbypassed automatically when the system is disarmed by
entering your passcode.
74-2760—1
What You See
1– BYPASS
2– PASSCODES
ENTER PASSCODE
(See Note 1 below.)
1– ENTRY/EXIT
2– PERIMETER
3 (ADDITIONAL
4 AREAS)
MASTER BEDROOM
NORMAL DISARMED
(Points are displayed)
MASTER BEDROOM
NORMAL BYPASSED
THE SMITH'S
(See Note 2 below.)
The Options menu displays.
M6960
The system prompts you to enter
a master passcode (unless it was
already entered within the last
M6949
30 seconds).
The Area menu displays. Continue
to press the UP or DOWN arrow
keys to scroll through a list of
M6961A
areas in your system.
The display shows two areas each
time an arrow key is pressed.
M6962
The first point and point status
displays.
M6963
The first word on the point status
line shows NORMAL if the point is
closed, ALARM if the point is
open, and TROUBLE if there is a
mechanical malfunction (see the
Troubleshooting section). The
second word on the point status
line shows the current point status
(ARMED, DISARMED or
BYPASSED).
The point and the new status
display.
M6964
The system displays the current
mode.
M6942
40
What Happens