Advertisement
Under the Range
Your range, like many other household
items, is heavy and can setie into sofi
floor coverings such as cushioned vinyl or
carpeting. men moving the range on this type
of flooring, use care, and follow these simple and
inexpensive instructions.
The range should be installed on a 1/4 inch thick
sheet of plywood (or similar material) as follows:
When the floor covering ends at the front of the
area that the range will rest on should
range, the
be built
up with plywood to the same level or
higher than the floor covering. This will allow
the range to be moved for cleaning or servicing.
STEP 2
Use only a 3-conductor, or if required a 4-
conductor range cord set as noted below. These
cord sets are provided with ring type terminals.
The electrical rating of the cord must be
volts minimum, 40 amperes.
when the appliance is installed in a mobile home
or where local codes do not permit grounding
through the neutral.
STEP 3
1. Locate connector block at the bottom rear of
range and remove rear wiring cover.
2. Directly below the connector block is a hole
with a knockout ring for accommodating conduit
fittings. Brackets provided are used to support
the flexible cord strain relief, which must be
securely attached to the cord set.
STRAIN RELIEF
(PROVIDED WIT
SET. NOT PART
28
STEP 4
Power Cord Installation-Insert
through power cord terminals so that the screws
pass through connector block terminals and
engage nuts. Tighten screws securely.
BLOCK
TERMINAL
Cable Direct Instiafion-Clamp bare wires
between the connector block terminals and
movable nuts with screws tightened securely.
1. Copper Wiring
125/250
Connect the neutral o; grounded wire of the
supply circuit to the neutral terminal of the
connector block, located in the center, The
power leads must be connected to the outside
SCREW-
-
NUT
=&
MOVABLE
NEUTRAL
TERMINAL
screws
POWER CORD
MOVABLE
BLOCK
TERMINAL
FLEXIBLE
CABLE
(( '011/;
Advertisement
