Advertisement
Proper care and cleaning are important so your range will give you efficient
and satisfactory service. Follow these directions carefully in caring for it to
help assure safe and proper maintenance.
BE SURE ELECTRIC POWER IS OFF BEFORE CLEANING ANY PART
OF THE RANGE.
A
If your range is removed for cleaning, servicing or any reason,
be sure anti-tip device is re-engaged properly when the range
is replaced. Failure to take this precaution could result in tipping of
the range and cause injury.
Lift-Up Cooktop
(on some models)
Some models have a cooktop that can be lifted up
for easier cleaning. To make cleaning easier, the
entire cooktop may be lifted up and supported in the
up position.
Be sure all surface units are turned off before
raising the cooktop. There are 2 side supports that
lock into position when the cooktop is lifted up. The
surface units do not need to be removed before lifting.
After cleaning under the cooktop with hot, mild soapy
water and a clean cloth, lower the cooktop. Be careful
not to pinch your fingers.
To lower the cooktop, push the rods back and gently
lower the cooktop until it rests in place.
Cooktop Surface Lamp
When changing a cooktop lamp, do not touch the
metal at the ends of the lamp.
The cooktop light is easily replaced with a fluorescent
tube of the same wattage. Before changing the lamp,
pull the plug to the range or disconnect the power at
the main fuse or circuit breaker panel.
To remove:
Lift the lamp cover by pulling the bottom edge
toward you and then up.
Place fingers on top near each end of the lamp.
Roll the top of the lamp gently toward the front of
the range and gently pull the lamp from the socket,
making sure it does not hit the lamp cover.
(on some models)
To replace:
Place fingers on the top near each
end of the lamp.
Press the lamp into the slots until
it snaps into place.
Move lamp cover down and snap
into place.
(continued next page)
21
Advertisement
